Our Services
- Home
- /
- Our Services
- Turn off power and inspect coils for dirt and debris.
- Remove surface dust, leaves, and buildup from coil fins.
- Apply coil-safe cleaning solution to dissolve dirt and grease.
- Rinse coils with low-pressure water to remove cleaner and residue.
- Clean and flush the drain pan and drain line.
- Check coil fins and straighten if needed for proper airflow.
- Reassemble panels and test system operation.
- Drain Line Cleaning – Cleared and flushed condensate drain line to ensure proper flow.
- Drain Pan Cleaning
- Freon Level Check (Inspection Only) – Checked refrigerant pressure and levels; no refilling performed.
- General AC Unit Check-Up
- Checked system pressures for signs of low refrigerant.
- Inspected lines and coils for oil or visible leaks.
- Scanned system with electronic detector.
- Used soap solution to confirm suspected leak area.
- Identified and documented leak location.
- Turned off power to HVAC system.
- Removed old thermostat and documented wiring.
- Installed new thermostat base and reconnected wires.
- Mounted new thermostat and restored power.
- Programmed and tested system for proper heating/cooling operation.
- Inspect the duct system for dust, debris, and mold.
- Remove vent covers and access panels.
- Use specialized vacuum and brushes to clean duct interiors.
- Sanitize ducts and components with approved antimicrobial solution.
- Clean vent covers and filters as needed.
- Check airflow to ensure system operates efficiently.
- Clean filters – removed and washed air filters.
- Clean blower – inspected and removed dust/debris from the indoor blower.
- Clean condenser – cleared debris and cleaned outdoor condenser coil.
- Clean evaporator coil – removed dirt and buildup for optimal heat exchange.
- Recharge Freon (if needed) – checked refrigerant levels and added Freon to specification.
- Test system operation – verified airflow, cooling performance, and proper operation.
- Removal of Old AC System – safely disconnected and removed existing equipment.
- Installation of New AC System
- Installation of New Heater Kit – connected to AHU as per manufacturer specifications.
- P-Trap Installation – 3/4” PVC installed for proper condensate drainage.
- Safety Flow Switch Installation – ensured proper system safety operation.
- New Metallic Stand Installation
- Armaflex Insulation – applied to copper tubing for thermal protection.
- Freon Recharge – R-454B charged to manufacturer specification.
- Plenum Reconstruction – rebuilt duct board (1.5”), Dade County approved.
- Tie Downs Installation – hurricane protection for outdoor unit.
- Electrical Rework – low and high voltage connections verified and updated.
- 10-year warranty on parts.
- 1-year warranty in labor.
- AC Filter Information – Filter Included
Supply and installation of UV light system in HVAC unit that helps prevent mold and bacteria, improves air quality, improves efficiency and reduces odor.
- Supply and installation of blown-in insulation
- Even distribution to required depth and coverage
- Air blowing and application using insulation equipment
- R-value adjustment to meet project specifications
- Job site cleanup after completion
- Installation of mini split system (indoor unit & outdoor condenser)
- Installation of insulated copper refrigerant lines
- Installation of exterior line cover
- Installation of communication/control cables
- Installation of outdoor unit wall bracket
- System startup and operational testing